Zen Black with Experiment Designer, Tiles / Positions, FRAP and FRET Analysisġ High sensitivity GaAsP detector for increased light sensitivity, 2 standard fluorescent photomultiplier tubes (PMT), AiryScan detector, AiryScan FAST option, and Transmitted light detector (T-PMT) Off-hour credits.

Detection from 390 to 750 nm freely configurable.

Up to 8 frames/sec with 512 x 512 pixels (max.

InVivo Scientific enclosure w/ environmental control (temperature and CO2).

High sensitivity GaAsP photodetector plus two PMTs for confocal and additional PMT for transmitted light.

Airyscan and Airyscan FAST Module for super resolution.Piezo stage to allow faster and more precise z movement.Motorized XY Stage, allowing large images and multi-point time-lapse imaging.Inverted Zeiss Axio Observer Z1 microscope with Definite Focus (focus maintenance).Imaging of weak fluorescence signals with high sensitivity AiryScan mode.Perform Quantitative Imaging (linear scanner).Super Resolution imagining with AiryScan (1.7X improvement over diffraction limited imaging) and Airyscan FAST.After booting the live media, start the installer and follow the guided installation procedure.The microscope is fully enclosed for heating and environmental control with media perfusion capabilities and CO2 control.We recommend to boot the drive in UEFI mode if listed. Each command uses the same device and media but boots the PC in a different firmware mode. For example, you might see UEFI USB Drive and BIOS USB drive. You might see separate commands for the same device.

From the setup utility, boot to the usb drive:.Create a bootable USB using Garuda Downloader or (DD/Etcher/Ventoy/Rufus).

UEFI is much preferred over BIOS whenever possible. If your firmware supports UEFI then configure your device to use UEFI only in its setup utility.Otherwise, the Linux kernel may not be able to detect your drive. Make sure that your device's SATA controller is set to AHCI mode in your device's setup utility.Check the manual of your device/motherboard for further info. It may not be possible to disable the latter explicitly - try clearing the secure boot keys instead. Common keys used: Esc, Delete, F1, F2, F9, F10, F11, or F12. Boot the PC and press the manufacturer specific key to open your device's setup utility.

Zen lite manual